Buying guide
Water resistance explained
What 30m, 100m and 300m ratings actually allow, why depth figures are misleading, and how to keep a watch sealed.
The depth printed on a dial is a laboratory pressure rating. It is not the depth you can take the watch to. This is the most misunderstood figure in watch buying.
What the ratings mean in practice
- 30m (3 bar). Splash resistant. Rain and hand washing only.
- 50m (5 bar). Brief immersion. Most makers advise against swimming.
- 100m (10 bar). Swimming and snorkelling.
- 200m to 300m (20 to 30 bar). Recreational scuba diving, particularly where the watch is a certified dive watch.
Manufacturers set their own guidance, so check the manual for your model. The ratings assume a new watch with intact seals.
What makes a true dive watch
The international standard for dive watches is ISO 6425. It requires a minimum rating of 100m, a way of timing a dive such as a unidirectional rotating bezel, legibility in the dark and additional testing of each watch. A watch marked "Diver's" followed by a depth is claiming compliance with that standard.
The parts that keep water out
- Screw-down crown. Threads into the case and compresses a gasket. It must be screwed fully home before the watch goes near water.
- Gaskets. Rubber or synthetic seals at the crown, caseback and crystal. They harden with age.
- Chronograph pushers. Unless the manual says otherwise, do not press them under water.
Looking after the seals
Water resistance is not permanent. Have the watch pressure tested periodically and whenever the caseback has been opened, for example for a battery change. Rinse it in fresh water after sea or pool use. Avoid hot showers and saunas, because heat and steam are harder on seals than depth.
Leather straps
A watch can be rated to 100m and still be unsuitable for swimming if it is on a leather strap. If you plan to swim in it, compare the bracelet or rubber strap version.
Browse watchesCompare side by side